[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Fwd: Returned mail: header syntax error, line ":"
- To: Multiple recipients of list BOOK_ARTS-L <BOOK_ARTS-L@xxxxxxxxxxxxxxxx>
- Subject: Fwd: Returned mail: header syntax error, line ":"
- From: Cris Takacs <CRISBOBTAK@xxxxxxx>
- Date: Tue, 16 Apr 1996 18:40:03 -0400
- Message-id: <199604162240.SAA23601@listserv.syr.edu>
- Sender: "The Book Arts: binding, typography, collecting" <BOOK_ARTS-L@xxxxxxxxxxxxxxxx>
From: MAILER-DAEMON@xxxxxxx (Mail Delivery Subsystem)
To: CRISBOBTAK@xxxxxxx, postmaster@xxxxxxxxxxxxxxxxxxxx
Date: 96-04-15 14:17:01 EDT
This is a MIME-encapsulated message
The original message was received at Mon, 15 Apr 1996 14:16:38 -0400
----- Transcript of session follows -----
553 header syntax error, line ":"
----- Original message follows -----
Date: Mon, 15 Apr 1996 14:16:38 -0400
Your problem sounds like "zoning". You are pushing left-over alum and oxgall
to one end of the tank with your comb. When you clean off the surface of the
tank before your next marble do it in this fashion: 1) Skim the surface with
a wooden board that exactly fits the width of the tank. 2) Lay a 3-4 inch
wide strip of newspaper on the end of the tank where you just completed your
skimming operation. Let it soak up the excess alum, ox gall and junk that
has been pushed there. If this doesn't stop the problem try cleaning the
whole surface by laying sheets of newspaper across the whole tank and then
stirring the size. Clean off that comb, too.
Good luck---->Cris Takacs