[Table of Contents] [Search]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: holes in bindings

I thought that all Kinko's were copy shops?


-----Original Message-----
From: Book_Arts-L: READ THE FAQ at http://www.dreamscape.com/pdverhey
[mailto:BOOK_ARTS-L@LISTSERV.SYR.EDU]On Behalf Of Larry Nebel
Sent: Friday, August 13, 1999 4:36 PM
Subject: Re: holes in bindings

> I have had holes drilled at Kinko's before and they turned out
> nice - but I get frayed edges when I try to do it. I'm probably doing
> something wrong. Is there a special kind of bit to use?
> Oh yes - I want holes through two pieces of chip board and about 35
> pieces of text weight paper.
> Amy

Yes you need a special drill  - ANY copy shop or printer can do this for you
--  most faster, better and much more competnetly than any Kinkos

Holes should cost you between 75 cents and $1.00 each for up to roughly two
(2) inches of clean paper

United Electronic Printers Inc. - AlcoPrint
39716 Fremont Boulevard
Fremont, CA 94538-1316

510/796-COPY (2679)

LarryHN@alco.com  --  http://www.alco.com

[Subject index] [Index for current month] [Table of Contents] [Search]