Re: [BKARTS] Question on Kutrimmer

[Jeanne Bennett <jcbennett@xxxxxxxxxx>]

Maria,
I had the same problem.  All I did was to tighten the two nuts at the top,
or hinge, of the cutting arm.  It worked for me.
Jeanne
----- Original Message -----
From: "Maria G. Pisano" <MGPstudio@xxxxxxx>
To: <BOOK_ARTS-L@xxxxxxxxxxxxxxxx>
Sent: Sunday, January 11, 2004 1:30 PM
Subject: Question on Kutrimmer


> A number of years back I purchased a tabletop model # 1071 Kutrimmer with
a
> 27" blade. Aside for the milllimiter off problem it has serviced me well.
> However, recently, when I go to lift the blade when I am ready to cut, the
blade
> slips down by itself, not yet all the way down, but about half way. Once I
begin
> cutting, than it restores itself, and the blade stays up, that is until
the
> next time I have to cut. Has anyone else had this problem with the
Kutrimmer
> and if so is there a way to adjust this?
> Thank you
> Maria
>
>              ***********************************************
>         See the Book_Arts-L FAQ at: <http://www.philobiblon.com>
>
>      *Postings may not be re-printed in any form without the express
>      consent of the author - Please respect their contributions & ©*
>
>         Archive maintained and suppported by Conservation OnLine
>                     <http://palimpsest.stanford.edu>
>              ***********************************************

             ***********************************************
        See the Book_Arts-L FAQ at: <http://www.philobiblon.com>

     *Postings may not be re-printed in any form without the express
     consent of the author - Please respect their contributions & ©*

        Archive maintained and suppported by Conservation OnLine
                    <http://palimpsest.stanford.edu>
             ***********************************************